Jim
Have you looked into the small drag race tires and wheels ran a few years
back. They might be what you want. A racer in Washington state has a small
front on his streamliner motorcycle.His name is Simon-Pierre Smith.
simon-pierre smith@pss.boeing.com
I think this is still a good address. try it.Make sure you type out the
whole name as shown.
If no good I might be able to get a phone number for you.
Glen
----- Original Message -----
From: "Waldron, James" <James.Waldron@CWUSA.COM>
To: <land-speed@autox.team.net>
Sent: Tuesday, December 03, 2002 2:42 PM
Subject: Small diameter front tires
> I'm trying to design a cycle with a very low front end. As a
> result, I am looking for a high speed tire with a max diameter of
> around 12 inches.
>
> Anyone know where such might be found?
>
> Do I have to go the machined aluminum route?
>
> Anyone have any experience (cost) with a custom unit?
>
> V or road-race branded would work (if shaved).
> Max speed (I hope) of 210 mph.
>
> Thanks,
> Jim.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|