Hmmm....I used a tubing notcher of the hole saw type and made every cut and
lots more with a single saw blade. The secret is to use lot of oil when
cutting...
mayf
----- Original Message -----
From: "Jim Webb" <jwebb@mastnet.net>
To: "Land-Speed" <land-speed@autox.team.net>
Sent: Sunday, December 01, 2002 4:48 PM
Subject: Re: Tubing notchers
> >From what I have seen, the LowBuck Notcher is a real deal. The guy I know
> that uses one has never had to swap the cutting die and he builds lots and
> lots of cages.
>
> The guy that built the cage for our truck used the joint-jigger type and
ate
> many, many hole saws - which he charged us for.
>
> I'm not sure what Joe Timney sells, but I'm always interested in learning
> more...
>
> Jim Webb
>
> -----Original Message-----
> From: owner-land-speed@autox.team.net
> [mailto:owner-land-speed@autox.team.net]On Behalf Of landspeedracer
> Sent: Sunday, December 01, 2002 11:08 AM
> To: Dick J
> Cc: lsr list autox
> Subject: Re: Tubing notchers
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|