Hey Dick
How tight do you want to wind it? The cam grinder can supply you with
anything you want and it doesn't matter if it is a Chrysler, ARDUN, SBF,
SBC or whatever. The tighter you wind the more power you will get and the
sooner it will blow up or wear out. The old standby 280 degrees .450 lift
gets you to 6000 or so and it goes up from there.
Dave the Hayseed
----- Original Message -----
From: "Dick J" <lsr_man@yahoo.com>
To: <land-speed@autox.team.net>
Sent: Tuesday, October 15, 2002 8:05 PM
Subject: hemi cam timing
> Anybody on the list have any experience with an early hemi for LSR use?
I'm looking for recommendations for cam lift and duration for both naturally
aspirated and blown applications. I've got two suggestions already and
would like a couple more. ("Build a SBC" doesn't count.)
> Dick J in East Texas
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/land-speed
/// what is needed. It isn't that difficult, folks.
|