In a message dated 11/20/01 8:51:03 AM Central Standard Time, kturk@ala.net
writes:
<< After much consideration, time and effort... I picked out my new Dial Bore
gage...
It's a Mitytoyo.. ( always remember spelling is an optional art form down
here) and Enco ( www.use-enco.com) had it for 224 bucks on special this
week... reads 1.7-2.4" and in ten thousands increments... They also had
some pretty cool magnetic stands and dial indicators I had to have....(
just like Miss Kathy had to have the dang Bird )
>>
Keith you did the right thing getting a gauge that will read in the tenths
when used for bearing measurements. I had it in my head you were going to
use on cylinders to check and see if they needed work. I have made a mandrel
to increase the capacity of mine maybe you could do the same. Larry
///
/// land-speed@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe land-speed
///
/// or go to http://www.team.net/cgi-bin/majorcool
///
///
|