This piece of bearing material was just shiny like chrome.. it fit
perfectly in the lifted surface of the bearing. it was like part of the Tri
Metal bearing seperated and this piece stuck on the bearing surface about
1/2" farther in it's rotation...
Not sure why a bearing would decide to flake like this... all the other
bearing's looked fine.... These are the TRW Ugly bearings or Clevitte 77U ..
I think that is what they are called... interesting... the crank on this
throw was perfect.... as it was on all others... K
----- Original Message -----
From: "Dave Dahlgren" <dahlgren@uconect.net>
To: "Keith Turk" <kturk@ala.net>
Cc: <land-speed@autox.team.net>
Sent: Sunday, November 26, 2000 6:58 AM
Subject: Re: Bearing wear
> might want to actually take it apart and find where it
> really came from there is no chrome in the bearing.. but it
> is on the roller lifters roller rockers and i thought you
> had a plated crank.. they are notorious for the chrome
> flaking off... BTW where it comes off is usually right next
> to the crack in the crank..
> Dahlgren
>
> Keith Turk wrote:
> >
> > Early last season I had rolled the bearing's out of the C Motor while we
> > were racing it... didn't see any appreciable wear.... well this morning
I
> > was about done cleaning up and decided to check them over once again and
do
> > a Leak Down on it... Well one of the bearing's had a Flake of what
looked
> > like Chrome sitting in the middle of it.. I think I could see where the
> > bearing had started to lift a bit and this was the peice that came
out...
> > not a scratch on the crank and I feel pretty comfortable that a new set
of
> > bearing's will take care of it... Just thought I would pass along the
> > thought.... Might have just saved myself an engine by checking it...
> >
> > Keith
|