Rich you called them roller and ball. I would have thought that it
might have been a caged needle bearings. I believe the company I work
for makes the caged needle assembly for those motors. I am not for
sure as that part is made at a different plant. One thing to take into
consideration is the hardness of the needle compared to the crank
surface. If the surface of the crank is too soft then you will end up
destroying the crank. If the needles are softer you will wind up
pounding the needles out of the cage especially on the rods. Remember
what a spun rod bearing looks like! My thought would be maybe some
type of hard chrome or other type of surface treatment coating that is
applied with heat. The needles are not chromed they are just polished
after grinding. I have seen these assemblies in cam bearings, but
never on the rods and mains. Thoughts of pounding from the rods and
end thrust control on the mains?
BillB
----- Original Message -----
From: <V4GR@aol.com>
To: <land-speed@autox.team.net>
Sent: Wednesday, September 20, 2000 6:38 PM
Subject: Outboards
> I went to look at some outboard motors today. Mercs. 2 liter 4
cylinder at
> 200 hp and a 3 liter V6, don't know the power. They do use roller
and ball
> bearings for rods and mains. I am thinking that offset grinding
welding and
> grinding back to original dia. may work. I am not sure nitriding
will strand
> up to roller bearing pressure. Also the powerheads are expensive.
> This weekend I went to the Silver State Race, at Wes Potters
suggestion. It
> was great. 80 miles of 2 lane blacktop wide open. Winner was an old
Tony
> Stewart Winston Cup car at 202 average. I was about 2 miles down a 5
mile
> straightway and the cars were moving when they went by. Rich Fox
>
>
|