Wait... I gotta tell you all a story... So Dave and I are sorting all this
out over the Phone...( Trust me this guy is doing everything he can to
include learning everything about a Rodeck oiling system in a Single day )
We tried everything to sort out where the Problem was... one step at a
time... So the Last step is to snatch the Motor and Prime the oil system
with the Pan off... to find the Leaking Bearing.... Makes good sense RIGHT?
Well Miss Kathy is out there helping me snatch the Motor and so on.... and
she cleans up for the last time and Dave and I have the conversation about
the Pan off test.... SOOOOO She asks is this going to get me Dirty.... and
I say " na sweets... it's just a Drill you pull the trigger while I sit down
here and hold the Bucket of Oil... and watch the Bearings".... HOW WAS I
SUPPOSED TO REMEMBER THE OIL PRESSURE LINE WASN'T CONNECTED..... Did I tell
her where to stand? hmmm ain't this special.... you can guess which other
list I am on.....
Keith ( I can live without sex... but No food or diet coke for a Month....
Geez these girls can't take a JOKE)
----- Original Message -----
From: "Wester Potter" <wspotter@jps.net>
To: "Keith Turk" <kturk@ala.net>; "Land-speed list"
<land-speed@autox.team.net>
Sent: Friday, September 15, 2000 7:56 PM
Subject: Re: It ain't over till it's over
>
>
>
> BUMMER! And I just bought a six pack of Diet Coke in anticipation of
seeing
> you.
>
> I'll bet that Strasburg Engineering in Lindon, UT would have a set in
stock.
> They will be at the Regional drag championships about now but I could call
> very early in the morning and find out.. There's places around here where
> you could get in to install them. USFRA club members or friends.
>
> Wes
>
>
> on 9/15/00 3:34 PM, Keith Turk at kturk@ala.net wrote:
>
> > Seems I picked up some trash in the Motor during it's Run it... Got all
the
> > Bearings to include the special order cam Bearings... SOOOO Guess
the
> > WOS is Going to be Postponed too.... Guess I will Just sit here and
Pout...
> >
> > Well Maybe not... I have done everything I could do... left nothing to
> > chance and absolutely done the best I know how to do... Can't feel bad
about
> > that...
> >
> > anybody still got a chance at a set of Durabond Small Block Cam Bearings
for
> > a Mid wieght non Rollerbearing Small Block on a Saturday Delivery? Oh
well
> > just a thougth.... Rodeck's main guy took the afternoon off to go to a
> > wedding soooo... I am outta luck there
> >
> >
>
>
|