In a message dated 02/23/2000 8:50:08 PM Pacific Standard Time,
saltracer@netscape.net writes:
<< What do ya'll think of running a 2" od extra thick wall driveshaft in our
flathead powered modified roadster? It would give a little extra room. And
do
you know who would sell this kind of driveshaft? Phil
>>
Phil,
My MR driveshaft is a little bigger, 2 1/2"-3" as I recall, but I think
that most driveshaft specialty shops could make you one out of about any size
tube that would take the HP. Remember, the 1908 to 1948 Ford driveshafts were
a solid 1" bar turning inside a hollow torque-tube. The only limit might be
the size tube that your couplers would require..............Ardun Doug in CA
|