Mayf, John, List,
I've been having e-mail troubles lately so I've been struggling to just
keep up with the discussion on cubes. It would seem that my life is quite
simple in this respect running the rotary engine. I'm curious though, what
specific measuring instrumant is being used to measure bore and stroke
directly? (Dial bore gage, vernier caliper, etc?) Is the measurement taken
at just one cylinder?
Sorry if this has already been covered, I've lost over 600 old messages in
the past two days and may have missed it. Gotto get the kid his own computer!
Chuck "No, I can't just 'pull a head'" Rothfuss
Past my bed time.
Pole Cat Hollow, NC
At 08:45 PM 2/15/2000, you wrote:
>At 08:40 AM 2/16/00 -0500, John Beckett wrote:
>>snip
>
>> Another thing to consider ambient at Bonneville can be 120 degrees in
>>the sun.
>>
>>John Beckett, LSR #79
>>
>>
>For sure, and if the tolls are at the same temp as the thingy being
>measured, it makes no difference. The problem occurs when the doo hicky is
>cold and the tools are warmer. The measured dimension is smaller as a result.
>
>mayf
|