Nuther question: If methanol likes 14:1 and 15:1
kind of CR, and I put it in a gas motor that is,
say 10:1, isn't that like taking a gas motor on
gas and cutting compression ratio down to 7:1? I
mean, isn't that existing 10:1 way too low for
Methanol?
--- ARDUNDOUG@aol.com wrote:
> Group,
> For IR (Hilborn-type) injectors there are
> some pretty standard
> starting-points regards nozzle size, bypass jet
> size, injector pump size,
> etc. when starting to use methanol. The folks
> at Laguna Lean-out (aka
> Hilborn) near Laguna Beach, CA can give you a
> good idea of the starting
> point.
> Eventually you will establish your own
> base-line and interpolate from
> there to correct for the addition of nitro,
> different altitudes, temps,
> humidity, etc.
>
> Ardun Doug King
>
=====
Dick J - - ECTA #72
G/FCC - FX/GMR
|