Keith,
If you have stock components in your front end, you need to
add 1/8 " toe-in as the tires will toe-out at speed. If you have poly bushings
everywhere and heim rod ends in your tie rods, you can get away with 1/16".
Chamber is ok at 0 degrees unless you have altered your ride height... then you
have to determine if your car is prone to negative chamber because it in
lowered( geometry stuff) This is a little hard to explain without drawings but
I can show you at Maxton. Good Luck Joe
>>> "Keith Turk" <kturk@ala.net> 03/23 10:21 PM >>>
any advice on what to set the front end up at... I am taking it in the
morning to have the tires balanced and the front end aliened... the caster
is preset at about 8 degrees and the question I have is what to set the
Chamber and toe in at?
Keith Turk
Austin Healey 100 / Bugeye / Box Sprite / Bonneville Land Speed Racer
Camaro (C Gas Altered )
|