Yep, the 3/16 rod/hole alignment didnt work. So happy he came over today.
----- Original Message -----
From: Perry Small <healeyguy@aol.com>
To: Tom Felts <tomfelts@windstream.net>
Cc: healeys <healeys@autox.team.net>
Sent: Mon, 04 Apr 2022 18:10:21 -0400 (EDT)
Subject: Re: [Healeys] OD problem update---BJ8
Understand that the lever was misadjusted by 40 thousands. Lining up using the
alignment pin does not always allow the O/D to operate properly. Glad that it
is working again.
Perry
Sent from my iPhone
> On Apr 4, 2022, at 1:21 PM, Tom Felts via Healeys <healeys@autox.team.net>
> wrote:
>
> Today is a good day. My OD rebuilder came by and after adjusting the OD
> lever, the OD goes in and out perfectly!! I'm happy. Thank you Andy--my
> rebuilder. We did do a pressure test ---max pressure was 325psi.
>
> Tom
_______________________________________________
Archive: http://www.team.net/pipermail/healeys
http://autox.team.net/archive/healeys
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|