Bob,
I use needle nose vice grips held vertically to install the retainer.
Cheers,
Bob Haskell
Austin Healey 3000 BN7/BT7 registrar
On 11/15/21 9:08 AM, Bob Begani via Healeys wrote:
>
> Thanks to those who helped me, I confirmed that the screws were not
> worn and I needed a new nylon bearing. It snaped around the ball so I
> applied lithium grease to the end and the sides of the stick and
> housing installed the screws. When for a ride noting that the
> shifting was nice and smooth like it should be. I did all this
> without removing the tunnel which makes it difficult to install the
> springs and circle clip retainer into the tower. Any suggestions?
>
> Regards,
>
> Bob Begani
>
> BJ8 67
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
ox.team.net
|