IT IS IN!! thank all for your comments. Thete is a little trick that I learned
to speed the process. I'll pass this on later
Tired and going to bed
----- Original Message -----
From: Bob Spidell <bspidell@comcast.net>
To: healeys@autox.team.net
Sent: Tue, 21 Sep 2021 17:34:16 -0400 (EDT)
Subject: Re: [Healeys] tranny installation--BJ8
I've done this a few times;Â IIRC it always takes a bit of fiddling to
get them to mate up. How far out is it; an inch or so the first motion
shaft is probably butting-up against the spigot bearing, any more and
you might be facing the same issue Simon said he had?
On 9/21/2021 2:18 PM, richard mayor via Healeys wrote:
> Can you be more specific?  Not sure why you even have the shifter
> still attached. It can poke you in the eye. You just need to make
> sure the tranny is in one of the gears so you can rotate the output
> shaft if necessary to make the input shaft splines mate with the
> clutch splines.
>
> On Tue, Sep 21, 2021 at 1:11 PM Tom Felts via Healeys
> <healeys@autox.team.net <mailto:healeys@autox.team.net>> wrote:
>
> Try as two of us can, we could not get the tranny back in the car.
> Is there a specific position it has to be to mate? I heard the
> shifter at about the 10 oclock position but that didn't seem to work.
>
>
>
> tom
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|