changed a leaking gasket on side of BT7 o/d. also replaced synthetic oil with
30ND. now cannot get o/d to engage.
solenoid worked fine on static check but would not engage o/d while driving.
ordered new solenoid and same situation.
started out with book instructions, no luck. tried other positions and will
not engage. if i push a little on right side arm it
engages immedietely. again, it was working fine before we changed the gasket
on the side plate and replaced o rings on
both sides of shaft. one thing i did notice was that o-ring on pax side was
flat and replacement was round. the solenoid
does not seem to be able to lift the arm while moving, but will when checking
it while stopped. any ideas?
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|