I'm gonna make a SWAG that racers routinely run at 6K RPM or more. I
rarely go over 3,500 RPM in my BJ8, with 3.54 diff, and the 100s are
known to break crankshafts if driven at 4K for long.  Either the gear
pumps run at reduced pressure at lower RPMs or the pulsed output of the
vane-type is causing the problems.
The DWM tech/sales people recommended the HC pump to me, and I asked
about their suitability; hence my questions about the company. From
their glossy catalog:
"We recommend the high capacity for all road engines using a standard
type crank up to 6000 rpm and the standard pump for race engines, steel
cranks or anything over 6000 rpm."
On 1/1/2020 3:43 PM, richard mayor wrote:
> We racers have known about the dangers of using the rotor style pumps
> for decades. I personally know more than half a dozen racers who
> destroyed their camshafts using high volume oil pumps back in the 90s
> - including me. I lost two camshafts! Jeff Johnk built a test bed,
> did extensive testing of more than 50 hours on both style pumps, and
> wrote an exhaustive article that appeared in the May, 1998, issue of
> Chatter, entitled Pumped Up For Racing.
> I suggest than anyone who is thinking about using a rotor style pump
> read this article first.
> Think about this for a minute. The rotor style pump caused problems in
> the 2.6 liter 100/6 motors. Austin changed to a gear style pump a
> month or so into the production of the 2.9 liter 3000 motors and the
> problems went away. Why would anyone want to use a 100/6 oil pump?
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|