--===============2322799757136571462==
--0000000000009bc4f405994e26a7
Hi Guys, I wrote earlier today but my email came back saying it was under
review because I am not a member, but I IS a member so trying again.
Anyway, my rear seat assembly is back from the restorer, problem is for the
life of me I cannot get the rear backrest (squab) to fit between the inner
wheel well frames, it just seems to be too wide, I am looking at the sledge
hammer but know this is the wrong approach, any thoughts and many thanks.
Brad Holden
--0000000000009bc4f405994e26a7
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">Hi Guys, I wrote earlier today but my email came back sayi=
ng it was under review because I am not a member, but I IS a member so tryi=
ng again. Anyway, my rear seat assembly is back from the restorer, problem =
is for the life of me I cannot get the rear backrest (squab) to fit between=
the inner wheel well frames, it just seems to be too wide, I am looking at=
the sledge hammer but know this is the wrong approach, any thoughts and ma=
ny thanks.<div>Brad Holden</div></div>
--0000000000009bc4f405994e26a7--
--===============2322799757136571462==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--===============2322799757136571462==--
|