Adjusting the forked steel strip under the cap will most likely sort
that out. loosen the nut slightly and move the strip as near as possible
to the centre without hitting something and start from there by levering
the strip to the outside very slowly using a plastic (not steel) tool.
adjust untill the pump is working at its fastest rate.
Aparently this happens fairly often.
Kees Oudesluijs
Op 30-11-2018 om 04:42 schreef healeymanjim:
> other than the 3 years i was stationed in spain i have driven my bj8
> continuously for about 400,000 miles since 1978 and it
> is still used daily. i have had a few pumps start to stutter but i make it
> home and replace the points. i always carry a spare
> pump and extra points just in case. i was really surprised that the solid
> state pump quit working after being stored in the
> boot as a spare for a few years. no moisture problems in las vegas, so
> wonder what the problem was.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|