"does the taper pin drift out from trans side or clutch side?"
Yes.
But seriously--did this a couple years ago and dammed if I ever figured
out for sure. Both ends were peined over and I really couldn't tell
even though I studied it for hours. My best guess is, because the
access hole is on the gearbox side, it was probably driven in from the
clutch side (so you could drive it out from the gearbox side). But
don't quote me; IIRC I ended up drilling it out.
Bob
ps. Bet David Nock knows ;)
pps. I put a plastic plug in the access hole because, you know, dirt.
On 10/19/2018 2:15 PM, healeymanjim wrote:
> replacing clutch fork bushings and cannot remember. does the taper pin drift
> out from trans side or clutch side?
> _______________________________________________
>
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|