Hi Tom, it's fairly simple.
You keep removing shims until the bearings tighten up when you snug up the
nut; then add shims about 0.002" at a time, until you reach a point where
the hub turns freely.
M
On Fri, Aug 24, 2018 at 7:09 PM Tom Felts <tomfelts at windstream.net> wrote:
> What's the procedure for determining how (size) shims to put in against
> the spacer? Are they for end float? If so, what is the procedure for
> measuring end float?
>
> tIA
> tom
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter at gmail.com
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180824/d40dd176/attachment.html>
|