You may try a bit of PE sheet wrapped around the metal tube, just
sticking out an inch or so. Once the paper tube is started you can
withdraw the plastic.
It is not always successful but you can give it a go.
Kees Oudesluijs
Op 18-6-2018 om 18:56 schreef Michael Oritt:
> I need to replace the paper 4" fresh air hose and in the past have had
> problems presenting it squarely to the metal vent fitting and getting
> it started.
>
> I have a feeling I am not alone here and wonder if anyone has devised
> a trick to get the tubing started so that it will slip on without
> tearing up the inner liner and foil.
>
> I am not up for removing the fender....
>
> Thanks in advance--Michael Oritt
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
>
> Archive: http://www.team.net/pipermail/healeys
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/coudesluijs
> at chello.nl
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180618/e8cbab79/attachment.html>
|