I would emphasize Rick's point about the pull handle screws ... use as short
screws as possible and grind the pointed end to a round end to prevent the
possibility of it breaking the glass.
Secondly be sure to carefilly clean the outer and inner wipes of any grit to
avoid scratches.
M
On Mon, May 14, 2018 at 2:47 PM +0200, "Tom Felts" <Tomfelts at windstream.net>
wrote:
also------make sure the "docking" rubber at the bottom of the door is intact
and not worn out.? If the window doesn't rest firmly against that when down,
the window will rattle.
tom
----- Original Message -----
From: Alan Seigrist <healey.nut at gmail.com>
To: Bob Spidell <bspidell at comcast.net>
Cc: Healey list <healeys at autox.team.net>
Sent: Sun, 13 May 2018 23:13:16 -0400 (EDT)
Subject: Re: [Healeys] Bj8 door glass
Make sure the rear channel in the door is not loose.? If it is loose your
window will eventually shatter.
On Sun, May 13, 2018 at 11:11 PM, Bob Spidell <bspidell at comcast.net> wrote:
Regarding the screws:
https://mossmotors.com/media/instructions/314-251.pdf
On 5/13/2018 5:57 AM, HealeyRick wrote:
You probably need new nylon guides, available from
Moss.? Take it apart, clean and lubricate and check for smooth
up and down.? If it jams, check that the channels aren't
kinked.? Make sure the screws holding the chrome grab handle
aren't too long or you'll scratch the windows.
Rick Neville
On Sun, May 13, 2018 at 7:48 AM Mitch Simmons
<Dayton21 at comcast.net> wrote:
Hello
I am about to fix my BJ8 roll up door windows....they are
loose and hard to roll up.
Any advice on this operation would be greatly appreciated as
always
Cheers
Mitchell
Sent from my iPhone
_______________________________________________
Archive: http://www.team.net/pipermail/healeys
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180514/5a6e0e6a/attachment.html>
|