healeys
[Top] [All Lists]

[Healeys] No start

Subject: [Healeys] No start
From: ynotink at msn.com (WILLIAM B LAWRENCE)
Date: Mon, 23 Apr 2018 23:17:50 +0000
References: <CAPAC+V4xChTpo=xk4pjozHtp4puAq8NDz7grJi8mJGR-BmwxQw@mail.gmail.com>, <1380096358.241094.1524500453612@mail.yahoo.com>
Have you installed an ammeter?

________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of jim <ab7vf at 
yahoo.com>
Sent: Monday, April 23, 2018 4:20:53 PM
To: healeys; Fred Wescoe
Subject: Re: [Healeys] No start



On Sunday, April 22, 2018, 5:56:48 PM PDT, Fred Wescoe <fredwescoe at 
gmail.com> wrote:


I have a sudden and confusing problem.

The car is a 66 BJ8 and will not start. It will not crank, there isn't an 
ignition light and the fuel pump does not run.  Nothing works electrically.  No 
blown fuses.

I have an alternator and negative ground on the car.  The car has started 
properly for the couple of years I have owned it (previously 35 years with a 
BJ7).  The battery is fully charged and shows 12.65 volts at the battery 
terminals.  Voltage at the starter solenoid to ground is 12.57.

When I jumper the positive terminal of the battery to the battery connection on 
the starter solenoid the car will start.  The voltage at the starter solenoid 
(with the car running and jumper removed) is 14.65 and the same at the battery 
terminals and the car continues to run properly.  So, the alternator is 
charging the battery, all electrical items work and all is fine at this point.

When I turn the car off, the same issue repeats and there is a no start, no 
ignition light or fuel pump condition, nothing working electrically.

What am I missing here and what do I check next?

Fred

66 BJ8


some 'ascii art'     {battery}_____{solenoid}____{starter}____{ground}
                                               \
                                                 \____{key switch}_____{fuel 
pump}____{ground}                                                               
             \
                                                                            
\___{solenoid operate winding}_____{ground}

with key off, voltage at battery and solenoid same ...No current draw on 
circuit ..
measure voltage at solenoid terminal...leave voltmeter connected to solenoid 
terminal ...turn on key (on only, not start)
note voltage at solenoid terminal...if there is high resistance between battery 
terminal and solenoid terminal, the voltmeter should decrease in voltage ..

Jim
-------------- next part --------------
An HTML attachment was scrubbed...
URL: 
<http://autox.team.net/pipermail/healeys/attachments/20180423/13d877f3/attachment.html>

<Prev in Thread] Current Thread [Next in Thread>