I trust the engine oil being used had the right concentration of Zinc
dialkyldithiophosphate? Proper concentrations should be 1500 to 1700 ppm.
Current engine oils are at about 500 ? 600 ppm.
Edward J. O?Neal, P.E., Pte.
Wadsworth O?Neal Associates, Inc.
6418 Commerce Park Drive
Fort Myers, Florida 33966
phone: (239) 245-8728
cell: (239) 410-6174
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of
warthodson at aol.com
Sent: Sunday, March 25, 2018 11:15 AM
To: healeys at autox.team.net
Subject: [Healeys] cam failure
A friend recently had a reground cam fail after a few years of normal use. The
engine had been professionally rebuilt. There are several possible
explanations, however one unusual thing he discovered is that the wear on the
lobes & tappets is only apparent on cylinders 4,5 & 6. The worst visible wear
is on the exhaust valve lobe/tappet of Cyl 6. & the least wear is on the
exhaust valve lobe/tappet of Cyl 4.
Cyls 1,2 & 3 appear to be in very good condition.
Does this suggest any specific cause for the failure?
He will be having the cam & tappets replaced & will be using a Piper Camshaft,
for an Austin Healey 3000, it is Part No. AH3BP270 (Fast Road) and is from a
?billet? and not a regrind.
Are the Piper Cams generally considered good quality?
Any comments on this subject would be appreciated.
Gary Hodson
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180326/a3f0e857/attachment.html>
|