Hello
I have just finished the running-in process (yesterday) with the BN3 using
Penrite Running-In Oil.
Hoo Roo
Patrick Quinn
Blue Mountains, Australia
-----Original Message-----
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Bob
Spidell
Sent: Monday, 5 March 2018 11:48 AM
To: healeys at autox.team.net
Subject: Re: [Healeys] Break in oil
My engine builder used Lucas 30W break-in oil. They also pre-filled the block
at the oil pressure line port.
Bob
On 3/4/2018 2:48 PM, David Masucci wrote:
> Hi all,
>
> Well I finally have my BJ8 engine almost ready to go back in the chassis.
> This rebuild includes minor mods including a Denis Welch DSW-8 cam and bucket
> followers (with pockets in the block) and high capacity oil pump. This cam is
> drilled to provide oil to each lobe. The engine was also balanced. Once
> broken in I plan to run 20W-50 Valvoline racing full synthetic with ZDDP,
> which I?ve run in my XJ6 since 2012 or so.
>
> Based on what?ve I?ve read, I should start and run the engine at 2000 RPM for
> 20 minutes or so. My question is what should I use for break in? There are so
> many types. Does anyone have a recommendation?
>
> Thanks as always.
>
> Dave
> 64 BJ8
> 72 XJ6
>
>
_______________________________________________
Archive: http://www.team.net/archive
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|