As I am ready to replace the stator wiring loom on the 56 100 BN2, I find the
old loom is completely stuck inside the tube.?I have no wires left on the
trafficator end.? Pulling the wire on the other end, there is no movement and I
am afraid I will break the little that is left from the brittle wires. (not
that I need them)
Any garage tricks to negotiate these 62 year old wires from the tube?? I
already tried WD40 and some modest heat applied to outside of the tube but no
luck yet.
Bert
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180305/fa4035f8/attachment.html>
|