I'm always struggling to find what goes where in my attempt to restore this BT7
Mk II. I spend hours Googling photos of various issues but this time, I
decided to ask silly question number 7.
Regarding the pass-through holes in the bulkhead, I think I've run things
through correctly for the most part. To speed things up for the remainder, I
thought I'd take a photo of my car and give each empty hole a number. If you
can provide guidance for the correct use of the holes I'd appreciate it. I'm
sure some if not most are not used and just need a blanking plug but I wanted
to make sure before I install the engine.
I THINK holes # 1,2 & 3 are empty and should get a blanking plug. Hole #4 and
5 are where the engine temp sensor cable and choke pass through? I have no
idea what hole # 6 is for. I ran the control for the cold air valve just above
hole #7 but I'm not sure what 7 is for.
Lastly, Inside of the car I've seen several photos of what looks like the choke
cable located UNDER the dash on the driver's side, often marked with a "C" on
the knob. For my car, Am I correct to run the choke control through the hole
in the dash just above the cold air control?
Best,
Dan Corning
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180220/9d20b7b3/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Bulkhead Holes.JPG
Type: image/jpeg
Size: 3652508 bytes
Desc: Bulkhead Holes.JPG
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180220/9d20b7b3/attachment-0002.jpe>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Dashboard Hole.JPG
Type: image/jpeg
Size: 2745965 bytes
Desc: Dashboard Hole.JPG
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180220/9d20b7b3/attachment-0003.jpe>
|