I gutted a donor voltage regulator (I saved my original) and made the necessary
wiring changes within it. No modification of the existing wiring harness was
required.
Al Malin
Tricarb
> On Sep 8, 2017, at 1:18 PM, Bob Simmen <rsimmen at nc.rr.com> wrote:
>
> With the amount of knowledge in this group, I am hopeful someone will be able
> to help.
>
> I am converting from a generator to an alternator an a 67 BJ8, negative
> ground system. There should be available a schematic/picture to build a new
> wire sub-assembly that would simply replace the existing voltage regulator.
> This would be without cutting any of the existing car wire harness, plug into
> the existing spade terminals on the car wire harness, and allow for
> conversion back to the generator and voltage regulator if needed.
>
> Thank you in advance.
>
> Have a great day!
> Bob
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: http://autox.team.net/mailman/options/healeys/amalin at
> mac.com
|