Mike
Note that the nut is an octagon, would fit better on an MG. And one of them is
threaded the other way around. I made my own socket from a very big hexagon
socket (46mm IIRC) that I grinded to an octagon.
Per
Skickat fr?n min iPhone
> 6 sep. 2017 kl. 00:01 skrev Michael MacLean <rrengineer.mike at att.net>:
>
> OK, figured out how to get bearing hub off rear axle with a bearing flange
> and slide hammer. Is the hub nut 2 3/16ths? Is there a socket available
> without the chamfer around the mouth of the socket so I can get it on that
> thin nut? Do you guys just buy a 2 3/16ths socket and grind the mouth flat?
> The nuts on my axle are all buggered up from someone in the past using a
> chisel to get them off and put them back on.
> Mike MacLean
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170906/feab8603/attachment.html>
|