Now I'm confused ... it looks like the glass should just slide out of
the inner frame; you're saying I have to remove the whole
kit-and-kaboodle, including the outer frame and frame-to-shroud seal?
Bob
On 4/8/2017 3:18 PM, Charlie Schott wrote:
> I've done it on a BJ8 and a BT7 windshield and it's not hard to do.
> Make sure that you have good corner brackets and the right length
> screws. The hardest part is pulling the lower seal thru the T slot.
> Use plenty of liquid dishwater soap and grab the end with vice grips
> to pull it.
>
> Regards,
>
> Charlie Schott
>
> -----Original Message----- From: Bob Spidell
> Sent: Saturday, April 08, 2017 1:51 PM
> To: Healeys
> Subject: [Healeys] BJ8 Windshield Replacement
>
> Listers,
>
> Anyone replaced the windshield--just the glass and enclosing seal--on a
> BJ8? I have new glass, would order the seal kit from Moss (part#
> 682-028), and have a 'pro' do the installation (unless this is easy
> enough for a ham-fisted DIYer). I don't want to pull the whole
> thing--wind wings and all--just the 'main' glass. Anybody done this, or
> is it best to let the pro do it?
>
> TIA,
> Bob
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/schottc at knology.net
>
|