Not sure about coating the water jacket with epoxy. I would think that would
impede heat transfer...
Bill Lawrence
BN1 #554
________________________________
From: Healeys <healeys-bounces at autox.team.net> on behalf of Bruce Steele
<healeybruce at roadrunner.com>
Sent: Saturday, February 11, 2017 12:02:11 AM
To: 'Healey List'
Subject: Re: [Healeys] Off comes the head...Update
So, the machine shop has gone through my block and low and behold, oil is not
seeping from the transverse oil gallery into the water jacket. They
pressurized the oil gallery to 70 PSI and it help pressure; nothing bleed into
the water jacket. Rather, the shop cooked out a bag full of sludge from the
water jacket in the back of the block. Apparently, the regular hot tank
dipping before didn?t dislodge all this gunk, and the circulating coolant would
dissolve just enough to foul the coolant with the oily mess that sure looked
like fresh motor oil mixing with the coolant. Fooled me, for sure. For good
measure, we will coat the water jacket with some epoxy, then rebuild the motor
with Denis Welch pistons, street cam, bucket lifters, hollow push rods and fly
wheel. I am excited to experience how it will run with the new DW parts to go
with my DW oil pump I installed years ago.
Bruce Steele
Brea, CA
1960 BN7
From: Bruce Steele [mailto:healeybruce at roadrunner.com]
Sent: Thursday, November 24, 2016 10:15 PM
To: 'Healey List' <healeys at autox.team.net>
Subject: Off comes the head...
Finally diving in to diagnose and fix the oil in the coolant. Hoping it's just
the head gasket, but since it started after the engine was done 11 years ago, I
am suspicious that it's the oil gallery-water jacket wall between number 4 and
5 cylinders seeping high pressure oil into the coolant. Has anyone actually had
or known anyone with this problem?
Bruce Steele
Brea, CA
1960 BN7
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170211/90bd5f73/attachment.html>
|