All--
Some time back I posted about possibly needing to ream out the carb bodies
and put in oversized shafts.
Due to the fine weather here in the mid-Atlantic I did not get around to
removing the carburetors until yesterday when snow was forecast--and
naturally did not happen.
In any case I disassembled everything this morning and--as many of you
predicted--the wear appears to be confined solely to the sections of the
shafts that pass through the carb bodies. There is a noticeable difference
in feel when I partially withdraw the shafts so they bear on the
non-bearing ends and so I am sure that standard shafts will do the trick.
Thanks as always for the good advice.
Best--Michael Oritt
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20170210/e2f26eb5/attachment.html>
|