Re: [Healeys] Leaking rear axle hub (BT7) following recent installation of new seal!

[Bob Haskell <rchaskell@earthlink.net>]

Phil,

I'm curious why you say there's no O-ring on this model.  What makes 
your hub different?

Cheers,

Bob Haskell
AHCA 3000 MkI registrar
http://www.ciahc.org/registry_3000mk1.php

On 09/13/2016 05:55 PM, philip fish wrote:
> Hi all,
> 6 months ago my local garage replaced the seal on the O/S rear axle
> which was weeping slowly. When I took the wheel and drum off today
> everywhere was covered in oil from a major leak. Previously the garage
> replaced the oil seal, bearing, bearing spacer, hub lock washer and the
> paper gasket. There is no O-ring on this model.
>
> Does anybody have any ideas what might have gone wrong? I assume the
> seal has completely failed. Any helpful advice I can pass onto the garage?
>
> Phil
>
>
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation  $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage: 
> http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
>
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys