Yeah Gary I noticed that too. Moss says 2. But I looked in an original parts
manual it specifies 4. None of the illustrations however show the front 2.
Wonder why.
Keith
On 05/13/16, warthodson@aol.com wrote:
Charlie,
The front side curtain bracket uses the same wing nut that is used to retain
the rear side curtain bracket. Moss #805-110
Interestingly, I can find the wing nut in the Moss online catalog, but Moss
says (2) are required. I think it should say (4) are required. Also, the wing
nut is not shown with the side curtains in their online catalog. Only with the
door accessories.
Gary Hodson
-----Original Message-----
From: Charlie Schott <schottc@knology.net>
To: Chris Dimmock <austin.healey@gmail.com>
Cc: Steve B. Gerow <steveg@abrazosdata.com>; healeys <healeys@autox.team.net>
Sent: Thu, May 12, 2016 6:39 pm
Subject: Re: [Healeys] Side Curtain Bracket
The post of the front side curtain bracket on a BT7 is threaded. I can't see
that it takes a nut, so why is it threaded? Or does it take a nut? Thanks.
Regards,
Charlie Schott
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|