[Healeys] overdrive

["healeymanjim" <healeymanjim@hansencc.net>]

i have also found an easier way to mate up o/d and trans without having to hold 
it.  i take a piece of welding wire, which is very strong, route it from the 
bottom of the oil pump and over the roller.  i then push the wire back down the 
same hole and use a bolt to twist the wire while holding down the roller with 
my finger.  after mateup, i then snip the wire at the bottom and gently pull it 
back through the hole.  works for me.
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys