I have been told by those who are supposed to know that the trick is to
push t he seal into the slot and not slide it across. I have tried but
still get the usual gap near the posts where the scuttle arcs.
Best--Michael Orittb
On Fri, Sep 26, 2014 at 3:29 PM, mike brooks <hypercubic@yahoo.co.uk> wrote:
> Craig,
>
> I had a very poorly fitting lower seal on my BN2 when I acquired it in
> 2005. A couple of years after that I got a new one from scparts and it
> fitted
> (and still does) perfectly. Although it is a few years ago, I do remember
> that
> the guy I spoke to was aware of the difficulty of getting a good fitting
> seal,
> and that he had taken some trouble in making sure theirs fitted properly.
> Mike Brooks
> '56 BN2
> Scotland
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michael.oritt@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|