Don't forget to disconnect the longitudinal throttle rod.
Undo front motor mounts. You might want to replace a bolt on each side with
a long bolt so the engine has an alignment guide.
Remove grille, radiator and fan
If you have the dampener with the bolted pulley, you can substitute two long
bolts and use this setup, with a big socket and breaker bar, to undo the big
nut:
http://www.pbase.com/stevegerow/image/93312770
Beyond removal of front pulley, have no further experience-based comment as
I haven't removed a camshaft - there'll be issues with removing the timing
gears and chain and removing the distributor drive and getting it all
aligned properly on reinstall.
--
Steve Gerow
Altadena, CA, USA
BN6
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|