The tech at Palo Alto Speedometer told me the bulb needs to have the correct
ether fill level; not too much or too little. The volume can vary depending
on the temperature when filled. When the gauge was repaired they noticed the
bulb may have had a "spot" of solder on it that may have damaged the bulb
when it was installed in the block.
John
-----Original Message-----
From: dwflagg@juno.com [mailto:dwflagg@juno.com]
Sent: Saturday, July 5, 2014 6:33 PM
To: michael.salter@gmail.com
Cc: jmsdarch@sbcglobal.net; healeys@autox.team.net
Subject: Re: [Healeys] Safety gauge - resolved
ether assumption is correct!!
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|