This is a very helpful link. It covers most issues you'll have, including
making a new fulcrum pin for your T/O leverage:
webpages.charter.net/bighealey/smitty/smitty2.htm
and a PDF:
healey6.com/Technical/Werner/Smitty.pdf
On Jun 18, 2014, at 11:49 AM, I Erbs wrote:
> Howdy,
> As I sort out my car I think the throw out bearing is not fully
> dis-engaging. Is this effected by the fulcrum bolt on the Toyota 5 spd. By
> that Imean, how can I adjust it? And can I do it without pulling the tranny
> yet again. Now I have the carpet kit installed and the tunnel screwed
> down....
>
> Ira Erbs
> Portland, OR
> _______ _______
> (______ \____1960 BT7____/ _______)
> (_________________________)
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/e-wilkins@cox.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|