Re: [Healeys] Start up after rebuild

[Bob Spidell <bspidell@comcast.net>]

Our engine builder recommended a high-temp epoxy on plugs. Haven't had one come 
out yet (also used one on the plug on the end of my BJ8's 'log' manifold after 
it popped out). 

I know--they'll be bears to get out if I ever need to. 

Bob 

----- Original Message -----

From: "Oudesluys" <coudesluijs@chello.nl> 
To: healeys@autox.team.net 
Sent: Saturday, January 11, 2014 2:01:21 PM 
Subject: Re: [Healeys] Start up after rebuild 

Tap in a new plug. You may use some sealant. 
Kees Oudesluijs 
NL 


Simon Atkinson schreef op 11-1-2014 20:39: 
> Well the solution was so simple I'm embarrassed to say..... 
> 
> Had the spark plug leads going clockwise around the dist by mistake! 
> 
> Fired right up!! 
> 
> Then after 5 mins before the champagne could be opened a welch plug flew off 
> the engine and hot water all over the place. Thank god no coolant in there 
> yet. 
> 
> I had someone rebuild the engine so do I just need to get some sealant and 
> reseat the plug? It's the one right next to the cylinder tap. 
> 
> Any advice? 
> 
> Thanks, 
> Simon 
> Cell 860-324-0248 
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys