They certainly fit well. I think it's an
advantage that they would grip the zinc diecast.
Peter C
---
At 09:47 AM 11/8/2013, Michael Salter wrote:
>I've not looked at Nord Lok as a possible
>solution but do you think that they are large
>enough that when positioned on the surface of
>the shock they would stop the problem of
>"sinking" into the soft zinc surface which I
>believe is the root cause of the problem?
>
>Michael S
>
>----------
>Sent: b2013-b11-b08 10:24 AM
>Subject: Re: [Healeys] Nord Lok washers
>
>Marketing question, if you'll permit.
>
>On this list's recommendation, I purchased some of these from
>McMaster. Beautiful. I think these might be the cure for loose shock
>fixings. We see tons of bad mounting holes, especially on Healeys.
>(I can say tons, as we scrap that much in a year of bad castings)
>
>Would it be helpful to supply or offer a set with each shock we sell
>for Healeys? They aren't expensive. Is it something you would want to use?
>
>Just wanting opinions.
>
>Thanks
>
>Peter C
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys@autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage:
>http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
>
>No virus found in this message.
>Checked by AVG - <http://www.avg.com>www.avg.com
>Version: 2014.0.4158 / Virus Database: 3629/6816 - Release Date: 11/07/13
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|