Finger tight is the correct way to install studs to get the correct torque
without compromising anything. I had this explained to me by my engine
builder many years ago. He was quite emphatic about this and not just about
the cylinder heads studs. Sorry, I cannot remember the precise reason, but I
have heeded his advice ever since.
Richard
> Date: Wed, 6 Nov 2013 19:54:25 -0500
> From: ahbt71@gmail.com
> To: healeys@autox.team.net
> Subject: [Healeys] Torquing Studs.2
>
> Just received and opened the box for the main cap bolt studs and nuts and
> the instructions from the manufacturer (ARP) say to put the studs in "Hand
> Tight Only" - in bold yet. This is at odds with what the BMC manual says
> but inline with my intuition.
>
> Mike Tobin
> Pepperell, MA
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mayorrichard@hotmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|