If you do not have a lathe you can probably chuck the threaded stud into an
electric drill and file or sand down the O.D.
Gary Hodson
-----Original Message-----
From: Magnus Karlsson <magnuskarlsson@bornet.net>
To: Graham Wilkie <glwilkie1@bigpond.com>
Cc: healeys <healeys@autox.team.net>
Sent: Sun, Sep 15, 2013 4:49 am
Subject: Re: [Healeys] Front Wheel Grease Retaining Cups (Reproductions).
You have just encountered a poor reproduction. They have been sold like this
for years. If you can't find original ones that are made to the correct
sizes,
you better try to mount the in a laithe and file down the surfaces that will
be in contact with the hub.
The fit should be a light press fit. You should almost be able to pull them
out by hand.
Magnus Karlsson
www.concourshealeys.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|