General good practice is to use new bolts and/or nuts for these kind of
applications. You never know how stressed they have been in the past.
Regarding the total cost for the rebuild these parts are only a small
outlay.
Kees Oudesluijs
NL
Op 20-8-2013 20:56, Elton Schulz schreef:
> Fellow Listers,
> Am requesting your wise advice again. I'm assembling my 3000 engine
> back from the machine shop. Is it ok to reuse the main and rod bearing
> nuts or should I spring for new nuts?
> Thanks in advance,
> Elton, BJ7 in progress
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|