Thanks for replying, Mike.
I thought they might be 1/2"NF but I couldn't get a 1/2" to go in. Turns
out that on my BJ7 it's a 1/4" pipe thread for the front three main
bearings and a 1/2" pipe thread for the rear main.
Elton
On 6/8/2013 6:35 AM, Mike Tobin wrote:
>
> Elton,
> Mine just happen to be sitting on the workbench - 1/2 nf (at least
> that thread cleaner goes right in).
> I just pulled up on them while tapping with a hammer and they came
> right out or presented a gap I could get a screwdriver in to pry the
> rest of the way. No real effort.
> Mike Tobin
>
> On Jun 6, 2013 12:00 AM, "Elton Schulz" <eschulz@frontiernet.net
>
> Fellow Listers,
> Anyone know the thread size of the center hole of the main bearing
> caps? I plan on using a slide hammer to pull them off the crank.
> Thanks,
> Elton
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/ahbt71@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|