| To: | john spaur <jmsdarch@sbcglobal.net> s=q20121106; t=1367446791; bh=z/mgI9v2DTXBtcLY+F++rPlnUJpOYybQ9xzeFOhmv98=; h=Received:Received:Date:From:To:Message-ID:Subject:MIME-Version: Content-Type; b=MJxWSK2TCCoI39cAim/2VNCuysfOE/LHtjHQ+ba8jaMDWOn7g8TtS+BoINd74I6Be 6FIZ7DuT2JO8Ew1qdu9SlocmOXCwxUXjrgsfeaPeqslBXjPGfFyp/5p2959hPkHuZr VyCDPKHkhqws5w2yLu8Z2quIfk94TMBpqJPtyWfhloCNs0Xa1v0jg5JWCBiNw/Glje +GAy78KsxftyIiLMNCa7tOqtkIXj0oo6b7rM0D5yEM9fuQHUT6PVn/aKzIbKUtf8UB fvnpkWC2Vzn3uL1mPs+BMy85JX54jqDBbn/AvGYc6J7BEOiLgGd41zsguEaKxoq02q sQVGfduFWd7xg== |
|---|---|
| Subject: | Re: [Healeys] Rear main bearing gasket sealer |
| From: | Bob Spidell <bspidell@comcast.net> |
| Date: | Wed, 1 May 2013 22:19:51 +0000 (UTC) |
| Cc: | healeys <healeys@autox.team.net> |
| Delivered-to: | mharc@autox.team.net |
| Delivered-to: | healeys@autox.team.net |
No, but I've used it elsewhere--mostly differential covers--with good results. I think it's the best goop there is for this type of application (if not using a gasket). But, the bearing cap is a tight, machined surface--gotta believe you'd scrape most of it off installing the cap. Bob -------------------------------- Bob Spidell - San Jose, CA ----- Original Message ----- Has anyone used Permatex The Right Stuff to seal the rear main bearing cap flat surfaces that contact the block? If so, what were the results? TIA John Spaur San Jose, CA _______________________________________________ _______________________________________________ Archive: http://www.team.net/archive Healeys@autox.team.net http://autox.team.net/mailman/listinfo/healeys |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | [Healeys] Rear main bearing gasket sealer, john spaur |
|---|---|
| Next by Date: | Re: [Healeys] BN2 Interior, Curtis Arndt |
| Previous by Thread: | [Healeys] Rear main bearing gasket sealer, john spaur |
| Next by Thread: | Re: [Healeys] Rear main bearing gasket sealer, john spaur |
| Indexes: | [Date] [Thread] [Top] [All Lists] |