I always thought that the c shaped wrench was called a carburetor wrench.
By looking for one on-line, I find that they are called an 'obstruction
wrench'. See example at
http://www.zorotools.com/g/00062629/k-G3335796?srccode=cii_10043468&cpncode=35-4981636-2&utm_source=channel_intelligence&utm_medium=referral&utm_campaign=shopzilla
This is the type wrench I use to get to those back carburetor nuts on my
BJ8.
(The Other) Len
Vacaville, CA, USA
1967 AH 3000 MkIII, HBJ8L39031
----- Original Message -----
From: <healeymanjim@hansencc.net>
To: <healeys@autox.team.net>
Sent: Monday, November 26, 2012 9:49 PM
Subject: [Healeys] carbs
> years ago i bought a set of cheap C wrenches from harbor freight. i have
> only used the 1/2 inch one and only to take the bottom nuts off the rear
> carb. they work well for that. once they are loose i can spin them off
> with my fingers.
> _______________________________________________
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|