Geoff,
I've taken the speedometer out of my BJ8 many times and never had to remove the
tripmeter reset knob. It's just a
matter of tilting it at a certain angle then pulling it out through the dash.
If necessary, push the tripmeter shaft up
while tilting it.
I wouldn't attempt removing the pin while the speedo is in the car. It's a
tiny roll pin, and should be removed--only
if necessary--very carefully on the bench with a suitably sized drift. If you
lose it I doubt you'll find a replacement.
Bob
On 11/21/2012 7:55 PM, gturl@sympatico.ca wrote:
> We are trying to remove the speedometer from our BJ8, but the trip odometer
> reset knob seems to be in the way. There appears to be a pin joining the knob
> and the shaft going into thspeedometer itself. Does this pin need to come out
> and if so, is there a trick to removing it? Any advice will be appreciated.
>
>
>
> Geoff and Carol
>
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell@comcast.net
*******************************************************************
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|