A friend recently had great difficulty removing two knock-offs. I don't think
he over tightened them & he definitely greased the threads as will as the
splines. They went on apparently normally. I am not sure what is wrong be
there must be some miss-match between the threads on the hubs & on the
knock-offs. The knock offs & the hubs were both repros, but tno necessarily
the same source. I agree, wheel bearing grease should be all that is
required.
Gary
-----Original Message-----
From: BJ8 Healeys <sbyers@ec.rr.com>
To: healeys <healeys@autox.team.net>
Sent: Mon, Nov 19, 2012 8:32 am
Subject: Re: [Healeys] Knock off grease
I've never used anything but the same grease I use to lubricate the wheel
bearings and splines -- high-temp wheel bearing grease. I've never
experienced knockoffs that were that hard to remove. What is your procedure
for tightening them? How frequently do you re-lubricate them?
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|