OK one for you racing guys: Ibm getting on with my BN1-based Ausca track car
(Kilmartin BN1 chassis, BN1 running gear, Alfa 1750 twin cam/5 speed, Ausca
fibrerglass body from the 1950s. (Note: there was also an Ausca built in the
US, but that was a later, rear engined racer). I have a 4 stud BN1 axle and
rear springs, but the body only weighs 55kg all up, and the Alfa motor an
transmission is about half the weight of a Healey drivetrain. It looks likely
that the rear springs will be too stiff, & there have been some suggestions
about removing leaves. Question: which leaves to remove?
Cheers
Peter Linn
Brisbane Oz
BN1 Ward Spl coupe
BN1 Holden V6
BN1/Ausca/Alfa (under construction)
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|